Home › BODY ELECTRICAL › LIGHTING › GLOVE BOX LIGHT

GLOVE BOX LIGHT > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH (for Regular Cab)

HINT:
Use the same procedures described for the LH side.



2. REMOVE FRONT DOOR SCUFF PLATE RH (for Double Cab)

HINT:
Use the same procedures described for the LH side.



3. REMOVE COWL SIDE TRIM BOARD RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE INSTRUMENT SIDE PANEL RH


    B160590
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B160593
  1. Remove the bolt.

  1. Remove the 3 screws.

  1. Detach the 3 claws and remove the finish panel.



6. REMOVE GLOVE BOX LIGHT ASSEMBLY


    B161133
  1. Detach the 2 claws.

  1. Remove the box light and then disconnect the connector.