Home › BODY › ENGINE HOOD / DOOR › HOOD SUPPORT

HOOD SUPPORT > DISPOSAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISPOSE OF HOOD SUPPORT ASSEMBLY


    B166020E02
  1. Horizontally fix the hood support in a vise with the piston-rod pulled out.

  1. Wear safety glasses. Gradually cut a part between A and B shown in the illustration using a metal saw and gradually release the gas.

    CAUTION:
    Be careful when drilling because shards of metal may fly about. Always use the proper safety equipment.

    NOTICE:
    The gas is colorless, odorless and nonpoisonous.