Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TELEVISION CAMERA

TELEVISION CAMERA > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL TELEVISION CAMERA ASSEMBLY


    B166197
  1. Attach the 3 clamps and install the television camera with the 2 bolts.

  1. Connect the television camera connector.



2. INSTALL TAIL GATE SERVICE HOLE COVER
  1. Using a T30 "TORX" wrench, install the service hole cover with the 8 screws.



3. CHECK TELEVISION CAMERA ASSEMBLY ANGLE


    E146632E01
  1. Move the shift lever to the R position and check the rear view image in the display has no lines or distortion and has good color.