Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL RECEIVER (for Regular Cab)

DOOR CONTROL RECEIVER (for Regular Cab) > REMOVAL

for Preparation Click here



1. REMOVE UPPER BACK PANEL GARNISH


B164740
  1. Detach the 10 clips and remove the back panel garnish.



2. REMOVE LUGGAGE COMPARTMENT BOX LH


B164747
  1. Remove the 2 clips.

  1. Detach the 3 claws and remove the luggage compartment box.



3. REMOVE LUGGAGE COMPARTMENT BOX RH


B164748
  1. Remove the 4 clips and luggage compartment box.



4. REMOVE FRONT DOOR SCUFF PLATE RH
  1. Remove the front door scuff plate .

    HINT:
    The procedures listed below are for the LH side.



5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH


6. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY RH


B164750
  1. Detach the 2 claws and remove the cover.



    B164749
  1. Remove the bolt and outer lap belt anchor.



    B164745
  1. Detach the 8 clips and remove the quarter trim panel.



7. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



8. REMOVE DOOR CONTROL RECEIVER


B164741E01
  1. Disconnect the door control receiver connector.

  1. Remove the bolt and receiver.