UNLOCK WARNING SWITCH > INSTALLATION |
| 1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY |
If reusing unlock warning switch assembly:
![]() |
Temporarily install the unlock warning switch.
Install the contact pin cap.
![]() |
Attach the 3 claws to install the cover.
![]() |
If replacing unlock warning switch assembly:
While pushing the pin, slide the switch to install the warning switch.
![]() |
Connect the unlock warning switch connector.
| 2. INSTALL LOWER STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column) |
![]() |
Attach the 2 claws to install the column cover.
Install the 2 screws.
| 3. INSTALL LOWER STEERING COLUMN COVER (for Manual Tilt and Manual Telescopic Steering Column) |
![]() |
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.