STEERING COLUMN ASSEMBLY (for Manual Tilt) > DISASSEMBLY |
| 1. REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) |
![]() |
Using a screwdriver, widen the claws attached to the upper bracket by approximately 1.0 mm (0.0394 in.).
Pull out the transponder key amplifier with the claws open.
| 2. REMOVE KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System) |
![]() |
Using a screwdriver, widen the claws attached to the upper bracket by approximately 1.0 mm (0.0394 in.).
Pull out the key cylinder light with the claws open.
| 3. REMOVE UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY |
Secure the steering column in a vise.
Using a center punch, mark the center of the 2 tapered-head bolts.
Using a 3 to 4 mm (0.119 to 0.159 in.) drill, drill a hole in the 2 tapered-head bolts.
![]() |
Using a screw extractor, remove the 2 tapered-head bolts, and then remove the upper steering column with switch bracket and the steering lock bracket from the steering column.
| 4. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY |
![]() |
Turn the ignition switch lock cylinder to the ACC position.
Push down the stop pin with a screwdriver and pull out the ignition switch lock cylinder.
| 5. REMOVE UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Detach the 2 claws and remove the switch.
| 6. REMOVE KEY INTERLOCK SOLENOID |
![]() |
Remove the 2 screws and key interlock solenoid from the steering lock.
| 7. REMOVE IGNITION SWITCH ASSEMBLY |
![]() |
Detach the 2 claws and remove the ignition switch from the steering lock.
| 8. REMOVE BREAK AWAY CAPSULE |
![]() |
Remove the 2 break away capsules and 2 break away collars from the steering column.
| 9. REMOVE STEERING COLUMN BRACKET SPACER |
![]() |
Using a brass bar, hammer and vise, gently strike the central part of the steering column bracket spacer and remove it.
Remove the No. 1 tilt steering support collar from the lower steering column tube.