STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > REASSEMBLY |
| 1. INSTALL STEERING COLUMN BRACKET SPACER |
![]() |
Fix the steering column in a vise between aluminum plates or a cloth. Then install the steering column bracket spacer to the steering column.
| 2. INSTALL BREAK AWAY CAPSULE |
![]() |
Install the 2 break away capsules and 2 break away collars to the steering column.
| 3. INSTALL IGNITION SWITCH ASSEMBLY |
![]() |
Attach the 2 claws to install the ignition switch to the steering lock.
| 4. INSTALL KEY INTERLOCK SOLENOID |
![]() |
Install the key interlock solenoid to the steering lock with the 2 screws.
| 5. INSTALL UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Attach the 2 claws to install the unlock warning switch to the steering lock.
| 6. INSTALL IGNITION SWITCH LOCK CYLINDER |
Check that the ignition switch lock cylinder is in the ACC position.
![]() |
Install the ignition switch lock assembly to the steering lock.
Check that the ignition switch lock cylinder is securely installed.
| 7. INSPECT STEERING LOCK OPERATION |
| 8. INSTALL UPPER STEERING COLUMN CLAMP WITH SWITCH BRACKET ASSEMBLY |
Temporarily install the steering column upper with switch bracket and the steering lock bracket with 2 new tapered-head bolts.
![]() |
Tighten the 2 tapered-head bolts until the bolt heads break off.
| 9. INSTALL TRANSPONDER KEY AMPLIFIER |
Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.
![]() |
Push the transponder key amplifier upward and install it to the upper bracket.
| 10. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU |
![]() |
Install the ECU with the 2 screws.
Connect the 2 ECU connectors.