Home › BODY › EXTERIOR › FENDER LINER (for Front Side)

FENDER LINER (for Front Side) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


B165877E01
  1. for Steel Type Bumper:
    Install the front fender splash shield.

    1. Install the fender splash shield with the 2 screws, clip and 2 new clips labeled A.

      Torque:
      5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    B166535E01
  1. for Resin Type Bumper:
    Install the front fender splash shield.

    1. Install the fender splash shield with the 2 screws and 2 clips.

      Torque:
      5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

    2. Install the pin hold clip so that its groove is vertical.



2. INSTALL FENDER APRON MUDGUARD SEAL LH


  1. for Steel Type Bumper:
    Install the fender apron mudguard seal.



    1. Install the fender apron mudguard with the 3 clips and 15 new clips labeled A.


      B165874E01

    2. w/ Front Fender Mudguard:
      Install the front fender mudguard .

    3. w/ Side Step:
      Install the side step .



  1. for Resin Type Bumper:
    Install the fender apron mudguard seal.

    1. Install the fender apron mudguard with the 2 clips and 15 new clips labeled A.



    2. Install the pin hold clip so that its groove is vertical.


      B166532E01

    3. w/ Front Fender Mudguard:
      Install the front fender mudguard .

    4. w/ Side Step:
      Install the side step .