Home › BODY › EXTERIOR › FENDER LINER (for Front Side)

FENDER LINER (for Front Side) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FENDER APRON MUDGUARD SEAL LH


  1. for Steel Type Bumper:
    Remove the fender apron mudguard seal.

    1. w/ Side Step:
      Remove the side step .

    2. w/ Front Fender Mudguard:
      Remove the fender mudguard .



    3. Remove the 18 clips and fender apron mudguard.


      B165874E02



  1. for Resin Type Bumper:
    Remove the fender apron mudguard seal.

    1. w/ Side Step:
      Remove the side step .

    2. w/ Front Fender Mudguard:
      Remove the fender mudguard .

    3. Using a screwdriver, remove the pin hold clip.



    4. Remove the 17 clips and fender apron mudguard.


      B165876E01



2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    B165877E03
  1. for Steel Type Bumper:
    Remove the front fender splash shield.

    1. Remove the 3 clips and 2 screws and fender splash shield.



    B165875E01
  1. for Resin Type Bumper:
    Remove the front fender splash shield.

    1. Using a screwdriver, remove the pin hold clip.

    2. Remove the 2 clips, 2 screws and fender splash shield.