Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B1445/45    Passenger Side Cool Air Bypass Damper Control

for Preparation Click here


DESCRIPTION

HINT:
Although the tester title says "Passenger Side", there is only one cool air bypass servo motor on this vehicle.

The cool air bypass servo motor sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the cool air bypass servo motor to any position. As a result, when the air conditioner is operating, the temperature of the air blowing toward the passenger's head area is controlled.

HINT:
Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.


DTC Code
DTC Detection Condition
Trouble Area
B1445/45
Cool air bypass servo motor position sensor value does not change even if air conditioning amplifier operates cool air bypass servo motor
  1. Cool air bypass servo motor
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM


E147168E04


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (COOL AIR BYPASS SERVO MOTOR TARGET PULSE)
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Cool Air Bypass Pulse
    Cool air bypass servo motor target pulse /
    Min.: 8
    Max.: 50
    Open: 8 (pulse)
    Close: 50 (pulse)
    -

    OK:
    The display is as specified in the normal condition.

    Result 
    Result
    Proceed to
    NG
    A
    OK (Checking from the PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from the DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
A


2.REPLACE COOL AIR BYPASS SERVO MOTOR (for Passenger Side)
  1. Temporarily replace the cool air bypass servo motor with a new one (Click here).

    HINT:
    Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
Go to step 4
OK

END (COOL AIR BYPASS SERVO MOTOR IS DEFECTIVE) 

4.REPAIR OR REPLACE AIR CONDITIONING HARNESS
  1. Repair or replace the air conditioning harness.


NEXT


5.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC again (Click here).

    OK:
    DTC is not output.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END