Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL RECEIVER (for Double Cab)

DOOR CONTROL RECEIVER (for Double Cab) > INSTALLATION

for Preparation Click here



1. INSTALL DOOR CONTROL RECEIVER


B165415E01
  1. Install the receiver with the bolt.

  1. Connect the door control receiver connector.



2. INSTALL LOWER QUARTER TRIM PANEL ASSEMBLY RH


3. INSTALL REAR DOOR SCUFF PLATE RH
  1. Install rear door scuff plate .

    HINT:
    The procedures listed below are for the LH side.



4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH


5. INSTALL REAR SEAT ASSEMBLY


    B166544
  1. Attach the 4 hooks on the back side of the seat and install it.

    NOTICE:
    Be careful not to damage the vehicle body.



    B165600E01
  1. Install the 6 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.



6. INSTALL SEAT FLOOR BOX


B165790
  1. Attach the claw to install the seat floor box.

  1. Install the 4 knobs.



7. INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH


B166416E01
  1. Attach the hooks to install the cover. Then close the cover and turn the knob.



8. INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH


    B166415E01
  1. Attach the hooks to install the cover. Then close the cover and turn the knob.



    B166545
  1. Pull the 2 seat adjusting handles and fold down the seat cushion.