Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL RECEIVER (for Double Cab)

DOOR CONTROL RECEIVER (for Double Cab) > REMOVAL

for Preparation Click here



1. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH


    B165598
  1. Pull the 2 reclining adjusting handles and fold up the seat cushion.



    B165788E01
  1. Turn the knob and open the cover. Then detach the hooks and remove the cover.



2. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH


    B165789E01
  1. Turn the knob and open the cover. Then detach the hooks and remove the cover.



3. REMOVE SEAT FLOOR BOX


B165790
  1. Remove the 4 knobs.

  1. Detach the claw and remove the seat floor box.



4. REMOVE REAR SEAT ASSEMBLY


    B165599
  1. Pull out the rear seat inner belts.



5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


6. REMOVE REAR DOOR SCUFF PLATE RH
  1. Remove the front door scuff plate .

    HINT:
    The procedures listed below are for the LH side.



7. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



8. REMOVE DOOR CONTROL RECEIVER


B165415E01
  1. Disconnect the door control receiver connector.

  1. Remove the bolt and receiver.