Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for CrewMax)

NAVIGATION SYSTEM (for CrewMax) > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The stereo jack adapter sends an external device sound signal to the navigation receiver through this circuit. The sound signal that has been sent is amplified by stereo component amplifier, and then is sent to speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, navigation receiver, or speakers.

WIRING DIAGRAM


E138084E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO JACK ADAPTER)


    E138085E01
  1. Disconnect the K5 receiver connector.

  1. Disconnect the J7 adapter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K5-3 (VAL+) - J7-1 (ALO)
    Always
    Below 1 Ω
    K5-2 (VAR+) - J7-2 (ARO)
    K5-5 (VA-) - J7-3 (ASGN)
    K5-5 (VA-) - J7-5 (AUXG)
    K5-6 (ADPG) - J7-4 (AUXO)
    K5-3 (VAL+) - Body ground
    Always
    10 kΩ or higher
    K5-2 (VAR+) - Body ground
    K5-5 (VA-) - Body ground
    K5-6 (ADPG) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)