CYLINDER HEAD > REPLACEMENT |
| 1. REPLACE INTAKE VALVE GUIDE BUSH |
![]() |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap out the guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
![]() |
Select a new guide bush (STD or O/S 0.05).
| Item | Specified Condition |
| Intake | 34.5 mm (1.36 in.) |
| Exhaust | 40.5 mm (1.59 in.) |
Machine the bush bore diameter of the cylinder head side to the diameter of the selected guide bush.
| Bush Size | Specified Condition |
| Use STD | 10.285 to 10.306 mm (0.405 to 0.406 in.) |
| Use O/S 0.05 | 10.335 to 10.356 mm (0.407 to 0.408 in.) |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard clearance between the guide bush and valve stem.
| 2. REPLACE EXHAUST VALVE GUIDE BUSH |
![]() |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap out the guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
![]() |
Select a new guide bush (STD or O/S 0.05).
| Item | Specified Condition |
| Intake | 34.5 mm (1.36 in.) |
| Exhaust | 40.5 mm (1.59 in.) |
Machine the bush bore diameter of the cylinder head side to the diameter of the selected guide bush.
| Bush Size | Specified Condition |
| Use STD | 10.285 to 10.306 mm (0.405 to 0.406 in.) |
| Use O/S 0.05 | 10.335 to 10.356 mm (0.407 to 0.408 in.) |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard clearance between the guide bush and valve stem.
| 3. REPLACE SPARK PLUG TUBE |
![]() |
Remove the spark plug tubes.
Apply adhesive to the end of a new spark plug tube.
![]() |
Using a wooden block and hammer, tap in the spark tube until it is protruding 40.9 to 42.1 mm (1.61 to 1.66 in.) from the camshaft bearing cap installation surface of the cylinder head.
| 4. REPLACE RING PIN |
Remove the ring pin.
Using a plastic-faced hammer, tap in new ring pins until they stop.
