Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING (for Regular Cab)

FRONT DOOR BELT MOULDING (for Regular Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE FRONT UPPER ARMREST BASE PANEL LH (w/ Power Window)


    B165649
  1. Using a screwdriver, detach the 2 clips and front upper armrest base panel.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors.



3. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B084267E03
  1. Insert a clip remover between the plate and trim.

  1. Turn the handle clockwise to remove the handle.



4. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B165652
  1. Detach the 3 clips and front lower door frame bracket garnish.



5. REMOVE COURTESY LIGHT ASSEMBLY (w/ Power Window)


    B165655
  1. Detach the claw and remove the courtesy light.

  1. Disconnect the connector.



6. REMOVE FRONT DOOR ARMREST COVER LH


7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B167314E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 10 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



8. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


B166364E02
  1. w/ Power Mirror Control System:
    Disconnect the connector labeled A.

  1. Remove the 3 nuts and claw.

  1. Remove the outer rear view mirror.



9. REMOVE FRONT REAR DOOR GUIDE BRACKET GARNISH LH


B166189E04
  1. Detach the 2 claws and remove the garnish.



10. REMOVE FRONT OUTER DOOR GLASS WEATHERSTRIP ASSEMBLY LH


B165857E01
  1. Put protective tape around the weatherstrip outer.

  1. Using a moulding remover, detach the claw and remove the weatherstrip.