WIPER AND WASHER SYSTEM > Washer Fluid Level Warning Switch Circuit |

| 1.READ VALUE USING TECHSTREAM (WASHER FLUID LEVEL WARNING SWITCH) |
Check the Data List for proper functioning of the washer fluid level warning switch.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Washer Switch | Washer fluid level warning switch / ON or OFF | ON: Washer jar is empty OFF: Washer jar is full | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK WASHER FLUID LEVEL WARNING SWITCH ASSEMBLY |
![]() |
Disconnect the A27 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A27-1 (S) - A27-2 (E) | Washer jar is empty | Below 1 Ω |
| A27-1 (S) - A27-2 (E) | Washer jar is full | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (WASHER FLUID LEVEL WARNING SWITCH - COMBINATION METER) |
![]() |
Disconnect the A27 switch connector.
Disconnect the J28 meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A27-1 (S) - J28-10 (WLVL) | Always | Below 1 Ω |
| A27-2 (E) - Body ground | Always | Below 1 Ω |
| A27-1 (S) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||