Home › DRIVE LINE › JF1A TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM > FAIL-SAFE CHART

for Preparation Click here



Malfunction Item
Fail-safe Operation
Indicator light
Fail-safe Deactivation Conditions
4WD control ECU malfunction
  1. 2WD to 4WD HIGH switching is not possible
  2. 4WD HIGH to 4WD LOW switching is not possible
4HI indicator light and/or 4LO indicator light blink at 0.2 second intervals
Ignition switch OFF
Wheel speed signal malfunction*1, *2
  1. 2WD to 4WD HIGH switching is not possible
  2. 4WD HIGH to 4WD LOW switching is not possible
4HI indicator light and/or 4LO indicator light blink at 0.2 second intervals
  1. When signal returns to normal
  2. During 2WD switching operation
  3. Ignition switch OFF
A/T shift position signal malfunction
4WD HIGH to 4WD LOW switching is not possible
4LO indicator light blinks at 0.2 second intervals
  1. When signal returns to normal
  2. During 2WD or 4WD HIGH switching operation
  3. Ignition switch OFF
Engine speed signal malfunction
4WD HIGH to 4WD LOW switching is not possible
A.D.D. actuator limit switch malfunction
  1. 2WD to 4WD HIGH switching is not possible
  2. 4WD HIGH to 4WD LOW switching is not possible
  3. During cruise control AUTO driving, cruise control system is turned OFF
4HI indicator light blinks at 0.2 second intervals
Ignition switch OFF
2WD-4WD transfer shift actuator limit switch malfunction
  1. 2WD to 4WD HIGH switching is not possible
  2. 4WD HIGH to 4WD LOW switching is not possible
  3. During cruise control AUTO driving, cruise control system is turned OFF
High-low transfer shift actuator limit switch malfunction
  1. 2WD to 4WD HIGH switching is not possible
  2. 4WD HIGH to 4WD LOW switching is not possible
4LO indicator light blinks at 0.2 second intervals

HINT:
  1. *1: When only 1 wheel's speed sensor is malfunctioning, the switching operation is performed based on the other 3 wheels. If the switch position and actuator match, fail-safe is deactivated.
  2. *2: When 2 wheels or more are malfunctioning, switching is not possible. If the speed sensor returns to normal, the fail-safe is deactivated.
  3. When the switching operation is performed during cruise control AUTO driving, if the switch completion does not occur 5 seconds after the switching operation, the cruise control system is turned off.