Home › ENGINE ยท 2UZ-FE › COOLING › RADIATOR

RADIATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE RADIATOR BRACKET SUB-ASSEMBLY


    A163497
  1. Remove the 4 bolts and 2 brackets.



2. REMOVE RADIATOR DRAIN COCK PLUG
  1. Remove the drain plug.

  1. Remove the O-ring.



3. ASSEMBLE SST


A113337E04
  1. Install the claw to part A of the overhaul handle as shown in the illustration.

    SST
    09230-01010  

  1. While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.

    Dimension B:
    0.2 to 0.3 mm (0.00787 to 0.0118 in.)



4. UNCAULK LOCK PLATE


A161775E01
  1. Using SST to release the caulking, squeeze the handle until stopped by the stopper bolt.

    SST
    09230-01010  



5. REMOVE RADIATOR TANK


A161776
  1. Lightly tap the bracket of the radiator (or inlet or outlet port) with a plastic-faced hammer and remove the tank.

  1. Remove the O-ring.