Home › TRANSMISSION · A750E AUTOMATIC TRANSMISSION › SHIFT LEVER ASSEMBLY (for Floor Shift Type)

SHIFT LEVER ASSEMBLY (for Floor Shift Type) > INSPECTION

for Preparation Click here



1. INSPECT TRANSMISSION CONTROL SWITCH


C146679E07
  1. Disconnect the transmission control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (IG) - 7 (S)
    Shift lever position S, "+" and "-"
    Below 1 Ω
    2 (SFTU) - 5 (E)
    Shift lever position continuously shifted to "+" (Up-shift)
    1 (SFTD) - 5 (E)
    Shift lever position continuously shifted to "-" (Down-shift)
    3 (IG) - 7 (S)
    Shift lever position not on S, "+" and "-"
    10 kΩ or higher
    2 (SFTU) - 5 (E)
    Shift lever position S
    1 (SFTD) - 5 (E)

    If the result is not as specified, replace the transmission floor shift assembly.