Home › DRIVE LINE › JF1A TRANSFER › 4WD CONTROL ECU

4WD CONTROL ECU > INSTALLATION

for Preparation Click here



1. INSTALL 4WD CONTROL ECU


    C160016
  1. Install the ECU with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 2 ECU connectors.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B160593
  1. Attach the 3 claws to install the finish panel.

  1. Install the 3 screws.

  1. Install the bolt.



3. INSTALL INSTRUMENT SIDE PANEL RH


    B163940
  1. Attach the 6 claws to install the side panel.



4. INSTALL COWL SIDE TRIM BOARD RH
  1. Install the cowl side trim board RH .

    HINT:
    Use the same procedures described for the LH side.



5. INSTALL FRONT DOOR SCUFF PLATE RH (for Regular Cab)
  1. Install the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



6. INSTALL FRONT DOOR SCUFF PLATE RH (for Double Cab, for CrewMax)
  1. Install the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.