LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat) > INSTALLATION |
| 1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH |
![]() |
Attach the 3 claws to install the bush.
![]() |
Install the lumbar support adjuster with the 2 screws.
Connect the lumbar support adjuster connector.
![]() |
Attach the 6 hooks to install the seatback spring.
Install the 2 springs.
| 2. INSTALL FRONT SEATBACK COVER WITH PAD LH |
Install seatback cover with pad to the seatback frame.
![]() |
Using hog ring pliers, install new hog rings to the seat frame.
![]() |
Attach the 4 claws to install the 2 headrest supports.
![]() |
Install the seatback cover bracket to the seat frame with the nut.
Install the seatback cover wires.
![]() |
Using hog ring pliers, install new hog rings to the seat frame.
![]() |
Attach the hook.
![]() |
Attach the wire harness clamp.
Connect the seat heater connector.
| 3. INSTALL INNER FRONT SEAT CUSHION SHIELD LH |
![]() |
Attach the 2 claws and clip to install the cushion shield.
Install the screw.
| 4. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH |
![]() |
Install the front seat inner belt with the nut.
Driver Side:
Connect the 2 connectors and attach the 4 clamps.
Passenger Side:
Connect the connector and attach the clamp.
| 5. INSTALL FRONT SEAT CUSHION SHIELD LH |
![]() |
Connect the switch connectors.
Attach the 2 claws to install the cushion shield.
Install the 3 screws.
![]() |
Install the 2 screws.
Using hog ring pliers, install the rubber band of the seatback cover to the seat frame with new hog rings.
| 6. INSTALL RECLINING POWER SEAT SWITCH KNOB LH |
![]() |
Attach the 2 claws to install the knob.
| 7. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH |
![]() |
Attach the 2 claws to install the knob.
| 8. INSTALL FRONT SEAT ASSEMBLY LH |
Install the front seat assembly (Click here).