AIR PUMP > INSPECTION |
| 1. INSPECT AIR PUMP ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 0.4 to 1.0 Ω |
| 1 - Body ground | Always | 10 kΩ or higher |
| 2 - Body ground |
![]() |
Check the operation of the air pump.
Check that air does not flow from port A to port B.
![]() |
Apply battery voltage to the connector, and check the air pump operation.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 1 | Air flows from port A to port B |