STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > ON-VEHICLE INSPECTION |
| 1. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Remove the 2 screws.
![]() |
Detach the 4 clips.
Detach the claw to remove the upper steering column cover.
| 2. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Detach the 2 claws to remove the lower steering column cover.
| 3. INSPECT TILT MOTOR |
![]() |
Disconnect the connector A from the multiplex tilt and telescopic ECU.
Connect the positive (+) battery terminal to terminal 10 (TIM+) and the negative battery terminal to terminal 1 (TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts up.
Connect the negative (-) battery terminal to terminal 10 (TIM+) and the positive battery terminal to terminal 1(TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts down.
| 4. INSPECT TELESCOPIC MOTOR |
![]() |
Disconnect the connector B from the multiplex tilt and telescopic ECU.
Connect the positive battery terminal to terminal 2 (TEM+) and the negative battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column contracts.
Connect the negative battery terminal to terminal 2 (TEM+) and the positive battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column extends.
| 5. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the steering column lower cover.
| 6. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips to install the upper steering cover onto the instrument panel cluster finish panel.
![]() |
Install the 2 screws.