OIL PUMP > INSTALLATION |
| 1. INSTALL OIL PUMP ASSEMBLY |
![]() |
Install the No. 1 thrust bearing race to the front oil pump.
| Item | Inside | Outside |
| Race | 74.2 mm (2.92 in.) | 87.74 mm (3.45 in.) |
![]() |
Coat a new O-ring with ATF, and install it around the oil pump assembly.
Place the oil pump through the input shaft, and align the bolt holes of the oil pump assembly with the transmission case.
Hold the input shaft, and lightly press the oil pump body to slide the oil seal rings into the overdrive direct clutch drum.
![]() |
Install the 10 bolts.
| 2. INSTALL AUTOMATIC TRANSMISSION HOUSING |
![]() |
Clean the threads of the bolts and case with non-residue solvent.
Install the transmission housing with the 10 bolts.