Home › TRANSMISSION ยท AB60E AUTOMATIC TRANSMISSION › OIL PUMP

OIL PUMP > INSTALLATION

for Preparation Click here



1. INSTALL OIL PUMP ASSEMBLY


C161631E01
  1. Coat a new O-ring with ATF, and install it to the oil pump.

  1. Install the 2 thrust bearing races to the front oil pump.

    Thrust bearing race diameter:
    Item
    Inside
    Outside
    Race A
    74.3 to 74.6 mm (2.93 to 2.94 in.)
    87.4 to 87.7 mm (3.44 to 3.45 in.)
    Race B
    38.0 to 38.3 mm (1.50 to 1.51 in.)
    53.9 to 54.1 mm (2.12 to 2.13 in.)



    C161629
  1. Pass the input shaft through the center hole of the oil pump, and align the bolt holes of the oil pump assembly with the transmission case.

  1. Hold the input shaft, and lightly press the oil pump body to slide the oil seal rings into the overdrive direct clutch drum.

  1. Apply seal packing to the flanges of the bolts.

    Seal packing:
    Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent

    NOTICE:
    Do not allow seal packing to contact the bolts' threads.

  1. Install the 10 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

    NOTICE:
    During installation, do not allow oil to contact the bolts or the surface of the oil pump body.



2. INSTALL AUTOMATIC TRANSMISSION HOUSING


C159660
  1. Clean the threads of the bolts and case with non-residue solvent.

  1. Install the transmission housing with the 14 bolts.

    Torque:
    34 N*m{ 345 kgf*cm , 25 ft.*lbf }