OIL PUMP > INSTALLATION |
| 1. INSTALL OIL PUMP ASSEMBLY |
![]() |
Coat a new O-ring with ATF, and install it to the oil pump.
Install the 2 thrust bearing races to the front oil pump.
| Item | Inside | Outside |
| Race A | 74.3 to 74.6 mm (2.93 to 2.94 in.) | 87.4 to 87.7 mm (3.44 to 3.45 in.) |
| Race B | 38.0 to 38.3 mm (1.50 to 1.51 in.) | 53.9 to 54.1 mm (2.12 to 2.13 in.) |
![]() |
Pass the input shaft through the center hole of the oil pump, and align the bolt holes of the oil pump assembly with the transmission case.
Hold the input shaft, and lightly press the oil pump body to slide the oil seal rings into the overdrive direct clutch drum.
Apply seal packing to the flanges of the bolts.
Install the 10 bolts.
| 2. INSTALL AUTOMATIC TRANSMISSION HOUSING |
![]() |
Clean the threads of the bolts and case with non-residue solvent.
Install the transmission housing with the 14 bolts.