AUTOMATIC TRANSMISSION SYSTEM > Pattern Select Switch Circuit |

| 1.INSPECT TOW/HAUL PATTERN SELECT SWITCH ASSEMBLY |
![]() |
for Column Shift Type:
Disconnect the J25 transmission control switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 12 (P) - 9 (E) | Tow/haul pattern select switch ON | Below 1 Ω |
| 12 (P) - 9 (E) | Tow/haul pattern select switch OFF | 10 kΩ or higher |
![]() |
for Floor Shift Type:
Remove the rear upper console panel sub-assembly .
Disconnect the J23 tow/haul pattern select switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 4 - 1 | Tow/haul pattern select switch ON | Below 1 Ω |
| 4 - 1 | Tow/haul pattern select switch OFF | 10 kΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
Install the rear upper console panel sub-assembly .
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (TOW/HAUL PATTERN SELECT SWITCH - BODY GROUND) |
![]() |
for Column Shift Type:
Disconnect the J25 transmission control switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J25-9 (E) - Body ground | Always | Below 1 Ω |
![]() |
for Floor Shift Type:
Remove the rear upper console panel sub-assembly .
Disconnect the J23 tow/haul pattern select switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J23-1 - Body ground | Always | Below 1 Ω |
Install the rear upper console panel sub-assembly .
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TOW/HAUL PATTERN SELECT SWITCH - ECM) |
![]() |
Disconnect the A24 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A24-51 (PWR) - Body ground | Tow/haul pattern select switch ON | Below 1 Ω |
| A24-51 (PWR) - Body ground | Tow/haul pattern select switch OFF | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||