Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for CrewMax)

NAVIGATION SYSTEM (for CrewMax) > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit is from the parking brake switch to the navigation receiver.

WIRING DIAGRAM


E138031E02


INSPECTION PROCEDURE

1.CHECK BRAKE WARNING SWITCH
  1. Check that the brake warning switch lights come on when the parking brake is applied and goes off when it is released.

    OK:
    The brake warning lights operate as specified above.



OK
Go to step 3
NG


2.INSPECT PARKING BRAKE SWITCH


    E071372E01
  1. Disconnect the A5 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A5-1 - Switch body
    ON (When shaft is not pressed)
    Below 1 Ω
    OFF (When shaft is pressed)
    10 kΩ or higher



NG
REPLACE PARKING BRAKE SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - PARKING BRAKE SWITCH)


    E145836E01
  1. Disconnect the K6 receiver connector.

  1. Disconnect the A5 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K6-1 (PKB) - A5-1
    Always
    Below 1 Ω
    K6-1 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)