BACK WINDOW GLASS (for CrewMax) > INSPECTION |
| 1. INSPECT BACK DOOR POWER WINDOW REGULATOR MOTOR |
![]() |
Inspect the operation of the power window regulator motor.
Check that the motor operates smoothly when battery voltage is applied to terminals 1 and 2 as follows.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 2 Battery negative (-) → 1 | Motor gear rotates counterclockwise |
| Battery positive (+) → 1 Battery negative (-) → 2 | Motor gear rotates clockwise |
| 2. INSPECT NO. 1 BACK POWER WINDOW RELAY (BACK P/W NO. 1 RELAY) |
Remove the power window relay from the engine room relay block.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 4 | When battery voltage is not applied between terminals 1 and 2 | Below 1 Ω |
| When battery voltage is applied between terminals 1 and 2 | 10 kΩ or higher | |
| 3 - 5 | When battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| When battery voltage is applied between terminals 1 and 2 | Below 1 Ω |
| 3. REMOVE NO. 2 BACK POWER WINDOW RELAY (BACK P/W NO. 2 RELAY) |
Remove the power window relay from the engine room relay block.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 4 | When battery voltage is not applied between terminals 1 and 2 | Below 1 Ω |
| When battery voltage is applied between terminals 1 and 2 | 10 kΩ or higher | |
| 3 - 5 | When battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| When battery voltage is applied between terminals 1 and 2 | Below 1 Ω |