Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG CUT-OFF SWITCH

AIRBAG CUT-OFF SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INSTRUMENT SIDE PANEL RH


    B160590
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B160593
  1. Remove the bolt.

  1. Remove the 3 screws.

  1. Detach the 3 claws and remove the finish panel.



4. REMOVE AIRBAG CUT-OFF SWITCH
  1. Detach the 2 claws to remove the switch.