Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.


    A237558E01


    Text in Illustration 
    *1
    Radiator Reservoir
    *2
    Radiator Cap
    *3
    Radiator Drain Cook Plug
    *4
    Cylinder Block Drain Cock Plug

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Tighten the radiator drain cock plug by hand.



3. REMOVE AIR CLEANER HOSE ASSEMBLY


    A238086
  1. Disconnect the ventilation hose and vacuum hose.

  1. Detach the wire harness clamp.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose.



4. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    A075597E01
  1. Disconnect the No. 5 water by-pass hose.



    A075598E01
  1. Disconnect the No. 4 water by-pass hose.



    A075599E01
  1. Disconnect the throttle position sensor and throttle control motor connector.

  1. Remove the 4 bolts, throttle body with motor and gasket.