FUEL INJECTOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
Disconnect the fuel pump ECU connector (Click here).
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch off.
Crank the engine again, then check that the engine does not start.
Loosen the fuel tank cap, then discharge the pressure in the fuel tank completely.
Connect the fuel pump ECU connector (Click here).
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE V-BANK COVER |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 5. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum hose and ventilation hose.
Loosen the 2 clamps.
Remove the air cleaner hose.
| 6. DISCONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the No. 2 fuel tube from the fuel pressure regulator (for quick type) (Click here).
| 7. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the fuel tube from the fuel delivery pipe RH (for quick type) (Click here).
![]() |
Disconnect the fuel tube from the fuel delivery pipe LH (for quick type) (Click here).
| 8. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY |
![]() |
Disconnect the No. 1 fuel pipe from the fuel delivery pipe LH (for quick type) (Click here).
| 9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY RH |
![]() |
Disconnect the ventilation hose and No. 6 wire harness connector.
Remove the No. 3 engine cover.
![]() |
Remove the 2 bolts and fuel delivery pipe RH.
Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head RH.
| 10. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY LH |
Disconnect the No. 7 wire harness connector.
Remove the No. 1 engine cover.
![]() |
Remove the 2 bolts and fuel delivery pipe LH.
Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head LH.
| 11. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Remove the fuel injector from the fuel delivery pipe, and then disconnect the injector connector.
![]() |
![]() |
Remove the O-ring from the fuel injector.
![]() |
Detach the 3 clamps and then remove the No. 6 wire harness from the delivery pipe RH.
![]() |
Detach the 3 clamps and then remove the No. 7 wire harness from the delivery pipe LH.