Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE SENSOR
  1. Connect the sensor connector (labeled A), and then attach the clamp (labeled B) to the hole of the sensor bracket.

  1. Install the yaw rate sensor with the 2 nuts (labeled C).

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

    NOTICE:
    1. Make sure that the sensor is oriented correctly.
    2. If the sensor is dropped, replace it.
    3. Securely connect the connector.

    4. When installing the sensor, make sure to avoid impacts to the sensor.


      C154452E02



2. INSTALL CENTER FRONT SEAT (for Center Seat)
  1. Install the center front seat.

    NOTICE:
    Be careful not to damage the vehicle body.



    B165564
  1. Connect the connector and install the 4 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



    B166412
  1. Install the center seat cushion carpet.



    B165810
  1. Close the center seat cushion.



3. INSTALL CONSOLE BOX ASSEMBLY (for Separate Seat Type)
  1. Install the console box .



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
  1. Perform the yaw rate sensor zero point calibration (Click here).



6. CHECK YAW RATE SENSOR SIGNAL
  1. Check the yaw rate sensor signal (Click here).