Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE CENTER FRONT SEAT ASSEMBLY (for Center Seat)


    B165562
  1. Open the center seat cushion.



    B165563
  1. Take out the center seat cushion carpet.



    B165564
  1. Remove the 4 bolts and disconnect the connector.

  1. Remove the center front seat.

    NOTICE:
    Be careful not to damage the vehicle body.



4. REMOVE CONSOLE BOX ASSEMBLY (for Separate Seat Type)
  1. Remove the console box .



5. REMOVE YAW RATE SENSOR
  1. Remove the 2 nuts (labeled A) and sensor.



  1. Disconnect the sensor connector (labeled B), and then detach the clamp (labeled C) from the sensor bracket.


    C154452E01