DTC P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0125 | Engine coolant temperature does not reach the closed-loop enabling temperature for 20 minutes (this period varies with the engine coolant temperature at engine start) (2 trip detection logic). |
|
| Related DTCs | P0125: Insufficient engine coolant temperature for closed-loop fuel control |
| Required Sensors/Components (Main) | Water inlet with thermostat, cooling system |
| Required Sensors/Components (Related) | Engine coolant temperature sensor and mass air flow meter |
| Frequency of Operation | Once per driving cycle |
| Duration | 63 seconds or more: Engine coolant temperature at engine start -3.33°C (26°F) or higher 127 seconds or more: Engine coolant temperature at engine start -14.44°C to -3.33°C (6°F to 26°F) 20 minutes or more: Engine coolant temperature at engine start below -14.44°C (6°F) |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not stored | P0101, P0102, P0103 (Mass Air Flow Sensor) P0112, P0113 (Intake Air Temperature Sensor) P0115, P0117, P0118 (Engine Coolant Temperature Sensor) P0128 (Thermostat) |
| Engine coolant temperature (closed-loop fuel control enabling temperature) | Below 5°C (41°F) |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0125) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| P0125 is output | A |
| P0125 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT WATER INLET WITH THERMOSTAT |
Remove the water inlet with thermostat (Click here).
Check the valve opening temperature of the thermostat.
Reinstall the water inlet with thermostat (Click here).
|
| ||||
| OK | |
| 3.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal radiator fan operation or any modifications.
|
| ||||
| OK | ||
| ||