Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below are for the LH side.



1. INSTALL OUTER MIRROR COVER LH (for Extended Type)


B251102
  1. Attach the 2 claws to install the cover.



2. INSTALL SIDE TURN SIGNAL LIGHT LENS (for Extended Type)


3. INSTALL OUTER MIRROR COVER (for Standard)


    B251086E01
  1. Attach the 3 claws labeled B.

  1. Attach the 4 claws labeled A to install the outer mirror cover.



4. INSTALL OUTER MIRROR LIGHT ASSEMBLY LH (for Standard)


    E139768
  1. Attach the 2 claws to install the light.

  1. Connect the 2 connectors.



5. INSTALL OUTER REAR VIEW MIRROR SUB-ASSEMBLY


B167460
  1. w/ Mirror Heater:
    Connect the 2 connectors.



    B167461
  1. w/ Retract Mirror:
    Connect the 3 connectors.



    B166389
  1. Attach the 4 claws to install the outer rear view mirror.

    NOTICE:
    Push the mirror downward until a "snap" sound is heard.



6. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


B166364E01
  1. Temporarily install the mirror by inserting the claw on the mirror into the holes on the vehicle.

  1. Tighten the 3 nuts in the sequence shown in the illustration and install the mirror.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

  1. w/ Power Mirror Control System:
    Connect the connector labeled A.



7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B165684E03
  1. Connect the 2 cables to the inside handle.

  1. Attach the inside handle's knob to the door trim board.

  1. Attach the 10 clips to install the door trim board.



    B167314E01
  1. Install the inside handle and door trim board to the door trim panel with the screw.

  1. Install the door trim board to the door panel with the screw.

  1. Attach the clip.



8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH


    B165652
  1. Attach the 3 clips to install the front lower door frame bracket garnish.



9. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B165697E01
  1. Install the plate and regulator handle with the snap ring.

    HINT:
    With the door window fully closed, install the plate and the regulator handle with the snap ring as shown in the illustration.



10. INSTALL FRONT ARMREST UPPER BASE PANEL (w/ Power Window)


    B165649E01
  1. Connect the connectors.

  1. Attach the 2 clips to install the front upper armrest base panel.



11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B165648E01
  1. Attach the 4 claws to install the bezel plug.