Home › BODY ELECTRICAL › LIGHTING › PERSONAL LIGHT ASSEMBLY (for Outer Rear View Mirror)

PERSONAL LIGHT ASSEMBLY (for Outer Rear View Mirror) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below are for the LH side.



1. REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY
  1. Push the upper part of the mirror surface and tilt it.



    B167982
  1. Using a moulding remover, push the bottom of the glass upwards as shown in the illustration. Slide the glass upwards to detach the 4 claws, and remove the glass.

    HINT:
    Apply protective tape to the outer rear view mirror to prevent it from being damaged.



    B167460
  1. w/ Mirror Heater:
    Disconnect the 2 connectors and remove the mirror glass.



    B167461
  1. w/ Retract Mirror:
    Disconnect the 3 connectors and remove the mirror glass.



2. REMOVE OUTER MIRROR LIGHT ASSEMBLY LH


    E139768
  1. Disconnect the 2 connectors.

  1. Detach the 2 claws and remove the light.