Home › TRANSMISSION ยท A760E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > DEFINITION OF TERMS

for Preparation Click here



Term
Definition
Monitor description
Description of what the ECM monitors and how it detects malfunctions (monitoring purpose and its details).
Related DTCs
Group of diagnostic trouble codes that are output by the ECM based on the same malfunction detection logic.
Typical enabling conditions
Preconditions that allow the ECM to detect malfunctions.
With all preconditions satisfied, the ECM stores the DTC when the monitored value(s) exceeds the malfunction threshold(s).
Sequence of operation
The priority order that is applied to monitoring if multiple sensors and components are used to detect the malfunction.
While a sensor is being monitored, the next sensor or component will not be monitored until the previous monitoring has concluded.
Required sensors/components
The sensors and components that are used by the ECM to detect malfunctions.
Frequency of operation
The number of times that the ECM checks for malfunctions per driving cycle.
"Once per driving cycle" means that the ECM checks for the malfunction only one time during a single driving cycle.
"Continuous" means that the ECM checks for the malfunction every time the enabling conditions are met.
Duration
The minimum time that the ECM must sense a continuous deviation in the monitored value(s) before storing a DTC. This timing begins after the "typical enabling conditions" are met.
Malfunction thresholds
Beyond this value, the ECM will conclude that there is a malfunction and store a DTC.
MIL operation
MIL illumination timing after a defect is detected.
"Immediately" means that the ECM illuminates the MIL the instant the ECM determines that there is a malfunction.
"2 driving cycles" means that the ECM illuminates the MIL if the same malfunction is detected again in the 2nd driving cycle.
Component operating range
Normal operation range of sensors and solenoids under normal driving conditions.
Use these ranges as a reference.
They cannot be used to judge if a sensor or solenoid is defective or not.