Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the airbag system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Check for DTC (Click here).
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    CHECK CAN COMMUNICATION SYSTEM (Click here)
    A


    4.WARNING LIGHT CHECK
    1. Check the warning light (Click here).


    NEXT


    5.CHECK DTC (Present and Past DTCs)*
    1. Check for DTC (Click here).
      Result 
      Result
      Proceed to
      DTC is output
      A
      DTC is not output
      B



    B.
    PROBLEM SYMPTOMS TABLE (Click here)
    A


    6.DTC CHART

      NEXT


      7.CIRCUIT INSPECTION

        NEXT


        8.REPAIR

          NEXT


          9.CLEAR DTC (Present and Past DTCs)*

            NEXT


            10.CHECK DTC (Present and Past DTCs)*
            1. Check for DTC (Click here).
              Result 
              Result
              Proceed to
              DTC is not output
              A
              DTC is output
              B



            B.
            Go to DTC CHART
            A


            11.CONFIRMATION TEST

              NEXT

              END