Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the ignition switch OFF.

  3. Connect the Techstream to the DLC3.

  4. Turn the ignition switch ON.

  5. Turn the Techstream on.

  6. Enter the following menus: Body Electrical / SRS Airbag / Data List.

  7. According to the display on the Techstream, read the "Data List".

    SRS Airbag: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Driver Seat Position
    Driver Seat Position/
    FORWARD: Seat position is forward
    BKWARD: Seat position is backward
    FAIL: Failure detected
    FORWARD/BKWARD
    -
    Passenger Classification
    Passenger Classification/
    NG: Data is not determined
    OFF: Vacant
    CHILD: Child (less than 36 kg (79.37 lb)) is seated
    AF05: Adult (36 to 54 kg (79.37 to 119.05 lb) is seated
    AM50: Adult (more than 54 kg (119.05 lb)) is seated
    FAIL: A failure is detected
    OFF/CHILD/AF05/AM50
    -
    Driver Buckle SW
    Driver Buckle SW/
    UNSET: The seat belt is not fastened
    SET: The seat belt is fastened
    NG: Data is not determined
    UNSET/SET
    -
    Passenger Buckle SW
    Passenger Buckle SW/
    UNSET: The seat belt is not fastened
    SET: The seat belt is fastened
    NG: Data is not determined
    UNSET/SET
    -
    Display Type Information
    Display Type Information/
    LR: The display is indicated by LH/RH
    DP: The display is indicated by Driver/Passenger
    DP
    -
    Number of Past DTC
    Number of Past DTC/
    Min.: 0, Max.: 255
    0
    -