Home › TRANSMISSION ยท AB60E AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


C161106
  1. Remove the nut and disconnect the cable.



2. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Disconnect the switch connector.



    C161107
  1. Remove the nut, spring washer and transmission control shaft lever RH.



    C161108
  1. Using a screwdriver, bend the tabs of the lock washer.



    C161109
  1. Remove the lock nut and lock washer.



    C161110
  1. Remove the bolt and switch.

    HINT:
    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.