OCCUPANT CLASSIFICATION SYSTEM > DIAGNOSIS SYSTEM |
| SYMPTOM SIMULATION |
![]() |
Vibration method: When vibration seems to be the major cause.
Slightly vibrate the part of the sensor considered to be the cause of the problem with your fingers and check whether the malfunction occurs.
Slightly shake the connector vertically and horizontally.
Slightly shake the wire harness vertically and horizontally.
The connector joint and fulcrum of the vibration are the major areas to be checked thoroughly.
Simulation method for DTC B1795: Turn the ignition switch from OFF to ON, hold it for 10 seconds, and then turn it back to OFF. Repeat this procedure 50 times in a row.
| FUNCTION OF PASSENGER AIRBAG ON/OFF INDICATOR |
Initial check
Turn the ignition switch ON.
The passenger airbag ON/OFF indicator (ON and OFF) comes on for approximately 4 seconds, then goes off for approximately 2 seconds.
Approximately 6 seconds after the ignition switch is turned ON, the passenger airbag ON/OFF indicator will be ON/OFF depending on the conditions listed below.
| Front Seat Passenger | ON Indicator | OFF Indicator | SRS Warning Light |
| Adult seated | ON | OFF | OFF |
| Child seated / Child restraint system set | OFF | ON | OFF |
| Vacant | OFF | OFF | OFF |
| Passenger occupant classification system failure | OFF | ON | ON |

| CHECK PASSENGER AIRBAG ON/OFF INDICATOR |
![]() |
Turn the ignition switch ON.
Check that the passenger airbag ON/OFF indicator (ON and OFF) comes on for approximately 4 seconds, then goes off for approximately 2 seconds.