Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > TERMINALS OF ECU

for Preparation Click here



CHECK NAVIGATION RECEIVER ASSEMBLY

E231112E05

  1. Disconnect the K30 navigation receiver assembly connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    K30-3 (ACC) - K30-7 (GND)
    GR - W-B
    ACC power supply
    Ignition switch off
    Below 1 V
    Ignition switch ACC
    11 to 14 V
    K30-4 (B) - K30-7 (GND)
    L - W-B
    Battery
    Always
    11 to 14 V
    K30-7 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

    1. If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the K30 navigation receiver assembly connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    K6-1 (PKB) - K30-7 (GND)
    R - W-B
    Parking brake signal
    Ignition switch ON, parking brake switch on
    11 to 14 V
    Ignition switch ON, parking brake switch off
    Below 1 V
    K6-3 (SPD) - K30-7 (GND)
    W - W-B
    Speed signal from combination meter
    Ignition switch ON, drive wheels turned slowly
    Pulse generation
    K6-5 (REV) - K30-7 (GND)
    G - W-B
    Reverse signal
    Ignition switch ON, shift lever in R
    11 to 14 V
    Ignition switch ON, shift lever not in R
    Below 1 V
    K30-1 (FR+) - K30-7 (GND)
    LG - W-B
    Sound signal (Front right)
    Audio system playing
    Waveform synchronized with sound is output
    K30-2 (FL+) - K30-7 (GND)
    Y - W-B
    Sound signal (Front left)
    Audio system playing
    Waveform synchronized with sound is output
    K30-5 (FR-) - K30-7 (GND)
    L - W-B
    Sound signal (Front right)
    Audio system playing
    Waveform synchronized with sound is output
    K30-6 (FL-) - K30-7 (GND)
    W - W-B
    Sound signal (Front left)
    Audio system playing
    Waveform synchronized with sound is output
    K30-10 (ILL+) - K30-7 (GND)
    SB - W-B
    Illumination signal
    Light control switch OFF
    Below 1 V
    Light control switch TAIL or HEAD
    11 to 14 V
    K31-1 (RR+) - K30-7 (GND)
    R - W-B
    Sound signal (Rear right)
    Audio system playing
    Waveform synchronized with sound is output
    K31-2 (RL+) - K30-7 (GND)
    Y - W-B
    Sound signal (Rear left)
    Audio system playing
    Waveform synchronized with sound is output
    K31-3 (RR-) - K30-7 (GND)
    W - W-B
    Sound signal (Rear right)
    Audio system playing
    Waveform synchronized with sound is output
    K31-5 (ILL-) - K30-7 (GND)
    BE - W-B
    Illumination signal
    Light control switch OFF → TAIL or HEAD
    Below 1 V → 11 to 14 V
    K31-6 (RL-) - K30-7 (GND)
    B - W-B
    Sound signal (Rear left)
    Audio system playing
    Waveform synchronized with sound is output
    K23-11 (V+) - K23-12 (V-)
    R - Shielded
    Television camera image signal
    Ignition switch ON, shift lever in R
    Pulse generation
    (refer to waveform 1)
    Ignition switch ON, shift lever in R, screen blacked out by covering camera lens
    Pulse generation
    (refer to waveform 2)
    K23-12 (V-) - K30-7 (GND)
    Shielded - W-B
    Shielded ground
    Always
    Below 1 V
    K23-13 (CA+) - K30-7 (GND)
    B - W-B
    Television camera power supply
    Ignition switch ON, shift lever in R
    5.5 to 7.05 V
    K23-14 (CGND) - K30-7 (GND)
    W - W-B
    Television camera signal ground
    Always
    Below 1 V
    K23-6 (SWG) - Body ground
    BR - Body ground
    Steering pad switch signal
    Always
    Below 1 V
    K23-7 (SW1) - K23-6 (SWG)
    LG - BR
    Steering pad switch signal
    No switch pushed
    2.16 to 2.81 V
    SEEK+ switch pushed
    0.00 to 0.37 V
    SEEK- switch pushed
    0.44 to 0.68 V
    VOL+ switch pushed
    0.98 to 1.38 V
    VOL- switch pushed
    1.57 to 2.09 V
    K23-8 (SW2) - K23-6 (SWG)
    GR - BR
    Steering pad switch signal
    No switch is pushed
    2.16 to 2.81 V
    MODE switch pushed
    0.00 to 0.37 V
    ON HOOK switch pushed
    0.44 to 0.68 V
    OFF HOOK switch pushed
    0.98 to 1.38 V
    VOICE switch pushed
    1.57 to 2.09 V
    K23-15 (ARI) - K30-7 (GND)
    P - W-B
    Aux sound signal (right)
    External device playing (When stereo jack used)
    Waveform synchronized with sound is output
    K23-16 (ASGN) - K30-7 (GND)
    G - W-B
    Ground
    Always
    Below 1 V
    K23-17 (ALI) - K30-7 (GND)
    L - W-B
    Aux sound signal (left)
    External device playing (When stereo jack used)
    Waveform synchronized with sound is output
    K23-18 (AGND) - K30-7 (GND)
    Shielded - W-B
    Shielded ground
    Always
    Below 1 V
    K23-19 (AUXI) - K30-7 (GND)
    SB - W-B
    External device connection detection signal
    External device playing (When stereo jack used)
    Waveform synchronized with sound is output
    K32-1 (SNS2) - K30-7 (GND)
    LG - W-B
    Microphone connection detection signal
    Always
    Below 1 V
    K32-2 (MIC+) - K30-7 (GND)
    R - W-B
    Microphone voice signal
    "Bluetooth" handsfree function on
    Waveform synchronized with sound is output
    K32-3 (MACC) - K30-7 (GND)
    B - W-B
    Telephone microphone assembly power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    4 to 6 V
    K32-5 (MIC-) - Body ground
    W - Body ground
    Microphone voice signal
    "Bluetooth" handsfree function on
    Waveform synchronized with sound is output
    K32-6 (SGND) - K30-7 (GND)
    Shielded - W-B
    Shielded ground
    Always
    Below 1 V
    J122-1
    #
    USB power source
    -
    -
    J122-2
    #
    USB data signal
    -
    -
    J122-3
    #
    USB data signal
    -
    -
    J122-4
    #
    USB ground
    -
    -

    1. #: There is no wire color information.
    1. If the result is not as specified, the receiver may have a malfunction.



  5. E171712E24
  6. Using an oscilloscope, check the waveform.

    1. Waveform 1
      Measurement Condition 
      Item
      Content
      Terminal No. (Symbol)
      K23-11 (V+) - K23-12 (V-)
      Tool Setting
      0.2 V/DIV., 50 μs/DIV.
      Condition
      Ignition switch ON, shift lever in R

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

    2. Waveform 2
      Measurement Condition 
      Item
      Content
      Terminal No. (Symbol)
      K23-11 (V+) - K23-12 (V-)
      Tool Setting
      0.2 V/DIV., 50 μs/DIV.
      Condition
      Ignition switch ON, shift lever in R, screen blacked out by covering camera lens

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

      Text in Illustration 
      *a
      Waveform 1
      *b
      Waveform 2
      *c
      Synchronized Signal
      *d
      Video Waveform