NAVIGATION SYSTEM (for DVD) > DTC CHECK / CLEAR |
| START DIAGNOSTIC MODE |
There are 2 methods to start diagnostic mode. Start the mode by using either of them.
![]() |
Method 1
Start the engine.
While pressing and holding the "INFO" switch, operate the light control switch: off → Turn on → Turn off → Turn on → Turn off → Turn on → Turn off.
The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.
Method 2
Start the engine.
![]() |
Press the "DISP" switch.
![]() |
From the display quality adjustment screen, touch the corners of the screen in the following order: upper left → lower left → upper left → lower left → upper left → lower left.
The diagnostic mode starts and the "System Menu" screen will be displayed.
| FINISH DIAGNOSTIC MODE |
Turn the ignition switch off.
| FAILURE DIAGNOSIS |
![]() |
Press the "Failure Diagnosis" switch on the "Service Menu" screen.
![]() |
The "Failure Diagnosis" will be displayed.
| SYSTEM CHECK |
![]() |
Press the "System Check" switch on the "Failure Diagnosis" screen.
![]() |
The "System Check Mode" screen will be displayed.
| CHECK DTC (CHECK USING SYSTEM CHECK MODE SCREEN) |
Read the system check result.
![]() |
If the check result is "EXCH" or "CHEK", touch the displayed check result.
![]() |
View the results on the "Unit Check Mode" screen and record them.
![]() |
When proceeding to view the results of another device, press the "Back" switch to return to the "System Check Mode" screen. Repeat the step above to view the results of other devices.
| DTC CLEAR/RECHECK (CLEAR USING SYSTEM CHECK MODE SCREEN) |
![]() |
Clear DTC
Press the "Memory CLR" switch for 3 seconds.
Confirm that the check results are cleared.
![]() |
Recheck
Press the "Recheck" switch.
![]() |
Confirm that all check results are "OK" when the check results are displayed. If a result other than "OK" is displayed, troubleshoot again.