Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Navigation Receiver Assembly Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the navigation receiver assembly.

WIRING DIAGRAM


E231656E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)


    E178447E29
  1. Disconnect the K30 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K30-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    K30-4 (B) - Body ground
    Always
    11 to 14 V
    K30-3 (ACC) - Body ground
    Ignition switch ACC
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Navigation Receiver Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)