Home › BODY › SEAT › CLIMATE CONTROL SEAT SYSTEM

CLIMATE CONTROL SEAT SYSTEM > TERMINALS OF ECU

for Preparation Click here



AIR CONDITIONING AMPLIFIER


  1. Measure the voltage and resistance according to the value(s) in the table below.


    E124486E32


    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J106-6 (SG-5) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    J106-8 (S5-2) - Body ground
    P - Body ground
    Power supply
    Ignition switch ON
    4.5 to 5.5 V
    J106-9 (SHD+) - Body ground
    R - Body ground
    Output climate control signal (Driver side)
    Ignition switch ON
    Seat heater switch LH blower side level 3
    Pulse generation
    (see waveform 1)
    J106-10 (SHP+) - Body ground
    BE - Body ground
    Output climate control signal (Front passenger side)
    Ignition switch ON
    Seat heater switch RH blower side level 3
    Pulse generation
    (see waveform 1)
    J106-15 (AD-4) - Body ground
    GR - Body ground
    Input climate control signal (Driver side)
    Ignition switch ON
    Seat heater switch LH level 0
    4.5 to 5.5 V
    Ignition switch ON
    Seat heater switch LH blower side level 3
    Below 1 V
    J106-16 (AD-5) - Body ground
    W - Body ground
    Input climate control signal (Front passenger side)
    Ignition switch ON
    Seat heater switch RH level 0
    4.5 to 5.5 V
    Ignition switch ON
    Seat heater switch RH blower side level 3
    Below 1 V
    If the result is not as specified, the air conditioning amplifier may have a malfunction.



      B188622E01
    1. Using an oscilloscope, check waveform 1.
      Measurement Condition 
      Item
      Content
      Terminal No. (Symbol)
      J106-9 (SHD+) - Body ground
      J106-10 (SHP+) - Body ground
      Tool Setting
      2 V/DIV., 500 μsec/DIV.
      Condition
      Ignition switch ON
      Seat heater switch blower side level 3