MAGNETIC CLUTCH RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT MAGNETIC CLUTCH RELAY (MG CLT) |
![]() |
Remove the magnetic clutch relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | When battery voltage is not applied between terminals | 10 kΩ or higher |
| When battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
Install the magnetic clutch relay.