Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE CYLINDER BOOT


    C201387
  1. Using a screwdriver, remove the 4 set rings and 4 cylinder boots from the disc brake caliper.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE FRONT DISC BRAKE PISTON


    C154480
  1. Install one side of the disc brake pad.

  1. Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.

  1. Using an air gun, gradually apply compressed air and remove the 2 disc brake pistons from the cylinder.

    CAUTION:
    Do not place your fingers in front of the pistons when using compressed air.

  1. Remove the brake pad and wooden plate.

  1. Temporarily install the 2 disc brake pistons that were removed. Then install the disc brake pad to the side in which the 2 disc brake pistons were temporarily installed.

  1. Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.

  1. Using an air gun, gradually apply compressed air and remove the 2 disc brake pistons from the other side of the cylinder.

  1. Remove the 2 disc brake pistons which were temporarily installed.



3. REMOVE PISTON SEAL


    C201386
  1. Using a screwdriver, remove the 4 piston seals from the disc brake caliper.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the inner cylinder or cylinder groove.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


5. REMOVE FRONT DISC BRAKE BLEEDER PLUG