Home › TRANSMISSION ยท A760E AUTOMATIC TRANSMISSION › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


D027914E04
  1. Install the spring and check ball body.



    C157293E01
  1. Align the hole of the manual valve with the pin of the lever and connect the pin to the manual valve.



    C157292E03
  1. Install the valve body with the 19 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    36 mm (1.42 in.) for bolt A
    25 mm (0.984 in.) for bolt B
    45 mm (1.77 in.) for bolt C
    50 mm (1.97 in.) for bolt D

  1. Install the detent spring and detent spring cover with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. CONNECT TRANSMISSION WIRE


C209349E01
  1. Connect the 9 solenoid valve connectors.

  1. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

    Torque:
    for bolt A:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }
    for bolt B:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    12 mm (0.472 in.) for bolt A

    36 mm (1.41 in.) for bolt B

  1. Attach the wire harness to the 2 clamps.



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


C209698
  1. Coat a new O-ring with ATF, and install it to the oil strainer.

  1. Install the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


C209348

NOTICE:
Be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install a new gasket and the oil pan with the 20 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



5. ADD AUTOMATIC TRANSMISSION FLUID
  1. Add automatic transmission fluid (Click here).