Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is normal, no sound, or only an extremely small sound, can be produced.

WIRING DIAGRAM


E130075E38


INSPECTION PROCEDURE

1.CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY


    E121567E06
  1. Disconnect the K15 stereo component amplifier assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K15-1 (MUTE) - Body ground
    Ignition switch ACC, Audio system playing
    Above 3.5 V
    Audio system changing modes
    Below 1 V



NG
Go to step 2
OK

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    E160624E06
  1. Disconnect the K4 radio receiver assembly connector.

  1. Disconnect the K15 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K4-7 (MUTE) - K15-1 (MUTE)
    Always
    Below 1 Ω
    K4-7 (MUTE) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE RADIO RECEIVER ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE RADIO RECEIVER ASSEMBLY (Click here)